Corner connection for our telescopic pull-out rods and connecting rods

Telescopic poles are the most commonly used tools for attaching cat nets to balconies, terraces, and gardens. It is therefore important that they are stable and strong enough to withstand wind and weather. Our extendable telescopic rods have a diameter of approx. 19 / 16 mm. To ensure that the cat net does not sag too much between the telescopic rods, they should be installed at a distance of approx. 2 m. Please note: to attach these telescopic rods, you need our telescopic rod holder for railing handrails. This telescopic rod cannot be stretched between floor and ceiling. Together with the telescopic rod holder, it provides a more permanent hold than telescopic rods for tensioning. The height of the telescopic rod can be continuously adjusted from 110 cm to 210 cm using the locking screw. A hole for attaching the braided line is located at both the top and bottom of the telescopic rod. The net can be easily attached there with a net tie together with our braided line, so that it cannot slip down and has a neat finish at the bottom. The inner telescopic rod is closed at the top with a plastic cap. The telescopic rod is open at the bottom so that any water that gets in can drain off.To prevent the cat from swinging over the net when climbing, we recommend our matching anti-climb protection for extendable telescopic rods. If you would like to use the extendable telescopic rods in the garden for a cat enclosure, we also recommend our lawn mounts for telescopic rods to ensure a firm footing. Please note: galvanizing does not offer the same weather resistance as hot-dip galvanizing or stainless steel. Depending on the weather conditions, especially rain and humidity, the telescopic poles may begin to rust over time. This is mainly a visual issue. The only alternative: telescopic rods made of stainless steel.

2-pieces connecting rod with a total length of 200cm. This connecting rod is required to build a net frame together with our connecting pieces (T-connection, corner connection and end connection) e.g. on the balcony. The rods have a diameter of 19mm and are tapered to 16mm at the ends. All tapered ends are equipped with a tripod spring that snaps into the hole provided in the connector.Available lengths: 200cm, 100cm, 10 to 50cm, 65 to 100cm and 120 to 190cm

Adjustable connection rod from 120 to 200cm. This connecting rod is required to adjust the frame length to match the length of the balcony. In combination with our other connecting rods, the required frame size can be precisely adapted. Colour: Electroplated. Silver-coloured galvanised.

Steplessly adjustable connecting rod from 80 to 115 cm. This connecting rod is needed to adjust the frame length according to the length of the balcony. In combination with the other connecting rods, almost any desired length can be assembled. Colour: electro-galvanised silver finish Frame system with extendable telescopic poles for a 3.5 m balcony with corner 1) End connection 2) T-connection 3) Corner angle connection 4) Connecting rod 200 cm 5) Connecting rod 100 cm 6) Connecting rod 120 - 190 cm 7) Extendable telescopic pole

This connection rod with a total length of 100cm and a diameter of 19mm (tapered at the ends to 16mm) fits all our connection pieces. In combination with the other connection rods, almost any desired length can be put achieved. The distance between the telescopic poles should not exceed 200cm. . Available in lengths: 200cm, 100cm, 10 to 50cm and 100 to 150cm Colour:  silver-colored galvanized

You need this screw set if you want to attach a Connecting Part of our Net Frame to our extendable telescopic rod.