It happens again and again that the four-legged friend climbs up the net and swings over the net and goes on a wandering journey. With our elegant telescopic pole attachment - made of steel, galvanized - which points inwards at an angle of about 115 °, climbing over is made difficult or prevented. . The telescopic pole attachment can easily be pushed onto the telescopic pole and fastened with the locking screw. . Please note that you need approx. 70cm more net height due to the angle attachment. . This telescopic pole attachment is only suitable for our extendable telescopic poles.

In order to obtain a higher stability of your balcony network, the telescopic rods are connected to each other by means of the connecting rods and connecting elements.. These end connections are placed ABOVE on the first and last telescopic rods for pulling out (on the insertion tube with 16mm Ø) and permanently fixed with the appropriate screws. Please note that all connecting elements offered CANNOT be attached to the lower end of the telescopic rod for pulling out. . If you also want to install a cross connection on the lower long side, then you cannot use the telescopic rods to extend it. In this case, you need to use the connecting rods. Then you can attach the connecting elements at the top and bottom (in this case, the connecting elements are placed on the connecting rod and secured by the tripod spring engaging). . CAUTION: You do NOT need a screw when inserting the fastener with the connecting rods. Screws are only required if the connecting elements are mounted on the telescopic rod for pulling out. . If you use the telescopic rods for pulling out, please do not forget to order the screws.

These net ties have the optimal length to attach a boy cat net to our pull-out telescopic poles and to our window net frame. These net ties can also be used to attach the heavy lead rope to the cat net without too much effort. . These net ties are suitable for the following items:      Window frame      Telescopic rods for pulling out      Connecting rods (frame system)      Climbing protection for pergolas and privacy screens .

In order to obtain a higher stability of your balcony network, the telescopic rods are connected to each other by means of the connecting rods and connecting elements. These T-connections are put on top of the telescopic rods for pulling out (on the insertion tube with 16mm Ø) and permanently fixed with the appropriate screw set. The distances between the telescopic poles should not be more than 2 meters. Please note that all offered connecting elements CANNOT be attached to the lower end of the telescopic rod for pulling out. If you also want to install a cross connection on the lower long side, then you cannot use the telescopic rods to extend it. In this case, you need to use the connecting rods. Then you can attach the connecting elements at the top and bottom (in this case the connecting elements are placed on the connecting rod and secured by the tripod spring engaging).CAUTION: You do NOT need a screw when the T-connector is used with the connecting rods. Screws are only required if the T-connection is mounted on our telescopic rod for pulling out.To secure the front of a 4m long balcony, for example, you need the following parts:2 x end connections + screws1 x T-connection + screws2 x connecting rods a 2.0m3 x telescopic poles to extend up to 210cm3 x telescopic rod brackets (wall bracket, railing bracket or wall brackets)1 x boy cat net1 x net tie (pack of 100 pieces)If the networking is to continue to the house wall, you need an additional corner connection and end connection. Please note our assembly instructions and techn. Drawings (see photo above)

Telescopic rod clamp made of hardened Aluminium, black or aluminium coloured anodized, for balconies with a square handrail with an edge length between 4,0 and 6,0cm. This bracket will be fitted to the railing with 2 screws only. This clamp is suitable only for our extendable Boy-Telescopic rods with a diameter of 19mm.

Where no drilling is allowed, these brackets are suitable for permanent attachment of the telescopic rod for pulling out on a round balcony handrail. The sturdy telescopic rod holder made of Aluminium is angled on the inside so that it tightly encloses the round handrail. The bracket is attached to the handrail with two long screws.The diameter of the round handrail must be between 30 and 60mm. This telescopic rod holder is specially dimensioned for our telescopic rods that can be pulled out. It can therefore happen that telescopic rods not supplied by us do not fit into the intended hole. These brackets are not suitable for the telescopic rods for tensioning.NEW - in the program: Telescopic rod holders for handrails up to a diameter of 85mm.

Telescopic poles are the most commonly used tools for attaching cat nets to balconies, terraces and gardens. It is therefore important that they are stable and strong so that they can withstand wind and weather. Our extendable telescopic rods have a diameter of approx. 19/16mm. . To ensure that the cat net does not sag too much between the telescopic rods, the telescopic rods should be attached at a distance of approx. 2 m. . Please note - to attach these telescopic rods you need our telescopic rod holder for railing handrails. This telescopic rod CANNOT be stretched between floor and ceiling. Together with the telescopic rod holder, it holds more permanently than the telescopic rods for tensioning. . The height of the telescopic rod can be continuously adjusted from 110 cm to 210 cm with the locking screw. A hole for attaching the braided line is located at the top AND bottom of the telescopic rod. The net can be easily attached there with a net tie together with our braided line, so that it cannot slip down or gets a straight end at the bottom. The inner telescopic rod is closed at the top with a plastic cap. The telescopic rod is open at the bottom so that any water that may have gotten in can drain off. . So that the cat cannot swing over the net when climbing, we recommend our suitable climbing protection for telescopic rods that can be pulled out. . If you would like to use the telescopic rods to pull them out in the garden for a cat enclosure, then we also recommend our lawn mounts for telescopic rods for a firm footing.Please note: Unfortunately, galvanizing does not have the same weather resistance as hot-dip galvanizing or stainless steel. Depending on the weather (rain/humidity), the telescopic poles can start to rust after a while. This is essentially a visual issue. . The only alternative => telescopic rods made of stainless steel.

With this wall corner bracket, telescopic rods can be attached directly to the corners of the balcony. This stable bracket can be used wherever drilling is permitted. It gives the telescopic rod a firm and permanent hold. This bracket must be attached with 4 screws.The only way that the cat net is really close to the wall in the corner.This telescopic pole holder is only suitable for our Boy telescopic poles with a diameter of 19mm. The telescopic rod can be adjusted to the desired height with the locking screw.Suitable for telescopic rods with a diameter of 19mmTube (bracket) length : 150 mmHolder plates material thickness : approx. 2.0 mmScrew holes diameter  : approx. 6.5 mmSurface:  Painting stove enamel or galvanizedColours:  white, black and galvanized silver coloured

With this sturdy corner mounting our BOY telescope bars are optimally mounted into the corner of your balcony. It will be fixed with 4 strong screws to the wall. Suitable only for our BOY telescopic rods with a diameter of 19mm. Available in the colours: white, black and galvanized silver coloured